Configuration of FTP using 3CDaemon

In this post I will show you the procedure to create a FTP using 3CDaemon tool. In Storage FTP is useful in uploading the Configuration and supportsave logs of Brocade Switch, firmware upgrade activity etc.
In case if you do not have FTP server you can install 3CDaemon (Filezilla) to a server and you can use it as FTP server.

You can download the 3CDaemon software from the below link.
http://www.firewall.cx/downloads/16-1-3cdaemon-server-a-client.html

Extract the Zip file and install (Setup.exe). Typical installation procedure (Next -> Next -> Install)

Click finish to complete the installation.

Once the installation completes open the 3CDaemon software.

You could see there are TFTP, FTP and Syslog options available in the tool. In this post we will concentrate only on configuring FTP site. Select FTP Server as shown below.

Click on Configure FTP server and go to FTP Profiles tab. (No need to make any changes in General Configuration tab)

Profile Name anonymous is a Built in profile and can not be deleted. So create a new Profile as shown below. Here I am creating a Profile "test" 

Set the password for the profile.

Set the User Directory, this will be your FTP directory. In this case I set the directory as "H:\MyFTP"

Click on Save Profile or Apply to save the changes made.

FTP will be accessed using the IP address of the Server where you have installed the 3CDaemon tool.


You can test your FTP as follow.
Open Windows explorer and enter ftp://IP_address (Here ftp://192.168.0.5). Provide the Profile Name and the password to access your FTP site. 

You will be able to access the FTP site and the folders inside the FTP directory. 



Comments

Post a Comment

Popular posts from this blog

Drive Replacement in HP 3PAR Storage Array

In this post I will explain the procedure to be followed for Failed Drive replacement in HPE 3PAR Storage array. Physically this activity will be taken care by trained 3PAR Field Engineer. However there are steps need to be followed before and after the drive replacement is explained here. Usually this will be done by the 3PAR support engineer if the 3PAR array is under support. Anyways there is no harm in getting to know about this stuffs he he. In HPE 3PAR there are 2 types of Drive cages (Drive Array Enclosure) depends on the model. 1. In 10000 and 20000 models in one Cage there will be 10 magazines and in one magazines there will be 4 drives. So in each cage there will be total of 40 drives. 2. Where as in case of 7000 and 8000 series there will be 24 drives in one cage (There is no magazine concept in mid range 3PAR arrays). If you have the Dial home configured for your 3PAR array an auto case will be created from 3PAR support end and they will contact regarding the f
Read more

HPE 3PAR Storage Array - Health Check

Image
This post explains the steps to perform basic health check on HPE 3PAR storage array. This will give you the overall status of the array for example Hardware failures, Host status, VV status, port etc. Lets start. Login to to 3PAR array and execute the command checkhealth. This gives you the overall health check as shown below. In this case you can see there are 4 errors/faults which need to be taken care. For a clear understanding on the errors/faults you can run checkhealth -detail instead of checkhealth. checkhealth -detail will show the details of the errors. Sample output is shown below. Now we will see how to fix the errors in this case. LDs not mapped to a volume - These LDs can be removed from the system but we need to confirm these are not being used by any LUNs. I will explain the procedure to remove these unused LDs in coming posts. License which have expired - You can ignore this as in this case Peer motion license was bought on trial basis. PD that a
Read more